Concrete Works

Critical steel ratio – only consider 250mm of concrete from outer face

The purpose of critical steel ratio is to control the cracking pattern by having concrete failing in tension first. If steel reinforcement yields first before the limit of concrete tensile strength is reached, then wide and few cracks would be formed. In the calculation of critical steel ratio, the thickness of the whole concrete section is adopted for analysis. However, if the concrete section exceeds 500mm in thickness, only the outer 250mm concrete has to be considered in calculating minimum reinforcement to control thermal and shrinkage cracks. It is because experimental works showed that for concrete section greater than 500mm, the outer 250mm on each face could be regarded as surface zone while the remaining could be regarded as core. The minimum reinforcement to control cracking should therefore be calculated based on a total maximum thickness of 500mm. 

Corrosion protection of lifting anchors in precast concrete units

The corrosion of lifting anchors in precast concrete units has to be prevented because the corroded lifting units cause an increase in steel volume leading to the spalling of nearby surface concrete. Consequently, steel reinforcement of the precast concrete units may be exposed and this in turns results in the corrosion of steel reinforcement and the reduction in the load carrying capacity of the precast units. To combat the potential corrosion problem, the lifting anchors could be covered with a layer of mortar to hide them from the possible external corrosion agents. Alternatively, galvanized or stainless steel lifting anchors can be considered in aggressive environment.

Concrete cover to enhance fire resistance

In the event of exposing the concrete structures to a fire, a temperature gradient is established across the cross section of concrete structures. For shallow covers, the steel reinforcement inside the structures rises in temperature. Generally speaking, steel loses about half of its strength when temperature rises to about 550 degree C. Gradually, the steel loses strength and this leads to considerable deflections and even structural failure in the worst scenario. Hence, adequate cover should be provided for reinforced concrete structure as a means to delay the rise in temperature in steel reinforcement. 

Differences between epoxy grout, cement grout and cement mortar

Epoxy grout consists of epoxy resin, epoxy hardener and sand/aggregates. In fact, there are various types of resin used in construction industry like epoxy, polyester, polyurethane etc. Though epoxy grout appears to imply the presence of cement material by its name, it does not contain any cement at all. On the other hand, epoxy hardener serves to initiate the hardening process of epoxy grout. It is commonly used for repairing hairline cracks and cavities in concrete

structures and can be adopted as primer or bonding agent.

Cement grout is formed by mixing cement powder with water in which the ratio of cement of water is more or less similar to that of concrete . Owing to the relatively high water content, the mixing of cement with water produces a fluid suspension which can be poured under base plates or into holes. Setting and hardening are the important processes which affect the performance of cement grout. Moreover, the presence of excessive voids would also affect the strength, stiffness and permeability of grout. It is versatile in application of filling voids and gaps in structures.

Cement mortar is normally a mixture of cement, water and sand (typical proportion by weight is 1:0.4:3). It is intended that cement mortar is constructed by placing and packing rather than by pouring. They are used as bedding for concrete kerbs in roadwork. They are sometimes placed under base plates where a substantial proportion of load is designed to be transferred by the bedding to other members.